Product ID:AMERCOR(R) 8750 CORROSION INHIBITOR
MSDS Date:05/31/1989
FSC:6850
NIIN:00N014881
MSDS Number: BKMMN

ASHLAND CHEMICAL COMPANY

ONE DREW PLAZA
BOONTON, NJ 07005
US

Emergency Phone: 606-324-1133

Info Phone: 201-263-7600

Cage: 0FUA8

ASHLAND CHEMICAL CO DREW INDUSTRIAL DIV

BOONTON, NJ 07005 US

Telephone: 201-263-7876

Cage: 0FUA8

CYCLOHEXYLAMINE (SARA III)

CAS: 108-91-8

RTECS: GX0700000

Fraction By Weight: 40-55%

OSHA PEL 10 PPM

ACGIH TLV: 10 PPM; 9192

MORPHOLINE

CAS: 110-91-8

RTECS: QD6475000

Fraction By Weight: 40-55%

OSHA PEL S,20 PPM/30 STEL

ACGIH TLV: S, 20 PPM; 9192

BE EXCLUDED FROM AREA OF SPILL UNTIL CLEAN UP

RTECS: 9999999ZZ

OF SPILL TO PVNT SPREADING, PUMP LIQ TO SALVAGE

RTECS: 9999999ZZ

EARTH, FLOOR ABSORBENT, OR OTHER ABSORBENT MATL &

RTECS: 9999999ZZ

OR OTHER BODIES OF WATER. IF RUN OFF OCCURS, NOTIFY

RTECS: 9999999ZZ

GIVE OXYGEN. IF BRTHG STOPPED, GIVE ARTIFICIAL

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYES: CAUSES BURNS. SKIN: VAPOR
CAN CAUSE IRRITATION AND DERMATITIS; LIQUID CAN CAUSE BURNS. BRTHG:
EXCESSIVE INHALATION OF VAPORS CAN CAUSE NASAL AND RESPIRATORY
IRRITATION INGEST: CAN CAUSE S EVERE GI IRRITATION, VOMITING,
DIARRHEA, SWEATING, WEAKNESS, HEADACHE. CHRONIC: OVEREXPOSURE HAS
(SEE EFTS OF OVEREXP)
Explanation of Carcinogenicity:NONE SPECIFIED BY MANUFACTURER.
Effects of Overexposure:HLTH HAZ: APPARENTLY BEEN FOUND TO CAUSE THE
FOLLOWING EFFECTS IN LAB ANIMALS: LIVER ABNORMALITIES, KIDNEY
DAMAGE, EYE DAMAGE.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:SKIN: IMMED FLUSH W/WATER FOR AT LEAST 15 MIN, GET MED ATTN.
REMOVE CONTAM CLTHG, LAUNDER BEFORE REUSE. EYES: IMMED FLUSH W/LG
AMTS OF WATER FOR AT LEAST 15 MIN. LIFT UPPER/LOWER LIDS OCCAS. GET
IMMED MED ATTN. IF MD IS NOT IMMED AVAIL, CON'T FLUSHING W/WATER.
INGEST: IMMED DRINK 2 GLASSES WATER & INDUCE VOMIT BY EITHER GIVING
IPECAC SYRUP OR BY PLACING FINGER AT BACK OF THROAT. (SEE SUPP
DATA)

Flash Point Method:TCC
Flash Point:110F,43C
Lower Limits:1.8%
Extinguishing Media:ALCOHOL FOAM, WATER FOG, CO*2, OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA AND FULL
PROTECTIVE EQUIPMENT . OPERATE IN THE POSITIVE PRESSURE DEMAND MODE
WITH FULL BODY PROTECTION WHEN FIGHTING FIRES.
Unusual Fire/Explosion Hazard:VAPS ARE > AIR & MAY TRAVEL ALONG
GROUND/BE MOVED BY VENT & IGNIT BY HEAT, PILOT LIGHTS, OTHER FLAMES
& IGNIT SOURCES AT LOCATIONS DISTANT FROM (SEE SUPP DATA)

Spill Release Procedures:SM SPILL: ABSORB LIQ ON PAPER, VERMICULITE,
FLOOR ABSORBENT, OR OTHER ABSORBENT MATL & TRANSFER TO HOOD. LG
SPILL: ELIMINATE ALL IGNIT SOURCES (FLARES, FLAMES INCLUDING PILOT
LIGHTS, ELEC SPARKS). PER SONS NOT WEARING PROT EQUIP SHOULD
(SEEINGRED 03)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:CNTNRS OF MATL MAY BE HAZ WHEN
EMPTIED. SINCE EMPTIED CNTNRS RETAIN PROD RESIDUE (VAP, LIQ, AND/OR
SOLID), ALL HAZ PREC GIVEN MUST BE (SEE OTHER PREC)
Other Precautions:HNDLG/STOR PREC: OBSERVED. DO NOT USE SODIUM NITRITE
OR OTHER NITROSATING AGENTS WITH PROD. SUSP CANCER-CAUSING
NITROSAMINES COULD BE FORMED. WHEN OPENING, REMOVE CLOSURES
CAREFULLY TO RELIEVE POSS IN TERNAL PRESS. NEVER USE PRESS TO
EMPTY.

Respiratory Protection:IF EXPOS LIMIT OF PROD OR ANY COMPONENT IS
EXCEEDED, A NIOSH/MSHA APPRVD AIR SUPPLIED RESPIRATOR IS ADVISED IN
ABSENCE OF PROPER ENVIRON CTL. OSHA REGS ALSO PERMIT OTHER
NIOSH/MSHA RESPIRATORS (NEGATI VE PRESS TYPE) UNDER SPECIFIED
CNDTNS.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLVS.
Protective Gloves:RESISTANT SUCH AS NATURAL RUBBER.
Eye Protection:CHEM WORK GOGFULL LGTH FSHLD
Other Protective Equipment:WEAR IMPERVIOUS BOOTS TO PREVENT SKIN
CONTACT.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLO HAZ: MATL HNDLG PT. EXPLO AIR-VAP MIX MAY FORM IF TEMP EXCEEDS
95F. NEVER USE WELDING/CUTTING TORCH ON/NEAR DRUM (EVEN EMPTY)
BECAUSE PROD (EVEN RESIDUE) CAN IGNITE EXPLO. FIRST AID PROC: NEVER
GIVE ANYTHING BY MOUTH TO UNCON PERSON.GET MED ATTN IMMED. INHAL:
REMOVE TO FRESH AIR. IF BRTHG DFCLT, (SEE INGRED 07)

HCC:F6
Boiling Pt:B.P. Text:259F,126C
Vapor Pres:[email protected]
Vapor Density:> AIR
Spec Gravity:0.950-0.970
pH:12.0
Evaporation Rate & Reference:UNAVAILABLE
Appearance and Odor:CLEAR WHITE TO CLEAR YELLOW LIQUID
Percent Volatiles by Volume:> 95%

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG ALKALIES, STRONG ORGANIC ACIDS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:THERMAL DECOMPOSITION OR COMBUSTION
MAY PRODUCE: CO*2 & CO, NITROGEN COMPOUNDS, VARIOUS HYDROCARBONS,
ETC.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH ALL LOCAL, STATE
AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.